MasterForce 241-0413 Návod k obsluze stáhnout pdf (Strana 14)

Page 13

OPERATION

LED WORKLIGHT (FIG. 7)

The LED worklight, located on the base of

the hammer drill, will illuminate when the

trigger switch is depressed. The LED

worklight will turn off when the trigger

switch is released. This provides additional

light on the surface of the workpiece for

operation in lower-light areas.

INSTALLING BITS (FIG. 8a, 8b)

1. Lock the trigger switch by placing the

direction of rotation selector in the OFF

(center) position.

2. Open or close the chuck jaws to a point

where the opening is slightly larger than

the bit size you intend to use.

3. Insert a drill bit.

WARNING:

Make sure to insert the

drill bit straight into the chuck jaws. Do

not insert the drill bit into the chuck jaws

at an angle and then tighten the chuck,

as shown in ﬁgure 8b. This could cause

the drill bit to be thrown from the hammer

drill, resulting in possible serious personal

injury or damage to the chuck.

NOTICE: Rotate the chuck body in the

direction of the arrow marked GRIP to

close the chuck jaws. Do not use a

wrench to tighten or loosen the chuck

jaws.

4. Tighten the chuck jaws securely on the

bit.

REMOVING BITS

CAUTION:

Use protective gloves

when removing the bit from the tool, or

ﬁrst allow the bit to cool down. The bit

may be hot after prolonged use.

1. Lock the trigger switch by placing the

direction of rotation selector in the OFF

(center) position.

2. Open the chuck jaws.

FIG. 8a

Keyless chuck

GRIP

(Tighten)

OPEN

(Release)

LED worklight

FIG. 7

FIG. 8b

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Komentáře k této Příručce

Žádné komentáře